Mount Bracket 700206701 Haydog Mount Base Fits Massey Ferguson MF2270 & Challenger LB34BXD Baler

The haydog mount 700206701 is the base bracket that carries the feed dogs inside the feeder chamber of Massey Ferguson and Challenger large square balers. Every tooth in the chamber pivots on this bracket, so it takes the full reaction load of the crop mat being pulled against the plunger face thousands of times a day.

When the mount bends or its pin holes oval, the dogs sit at the wrong angle and no amount of new teeth will restore a firm grip. Checking the bracket is therefore the first step of any feeder diagnosis. Replacing a distorted mount brings the dog geometry back to the factory position and stops the uneven wear that spreads to the pivot pins.

• Heavy plate construction with the original hole pattern so the dogs sit at the correct factory angle.
• Reinforced pivot bosses resist ovaling under the constant reaction load from the crop mat.
• Flat mounting face ensures full contact with the feeder frame, avoiding the flex that cracks welds nearby.
• Interchangeable with the original AGCO bracket, allowing replacement without cutting or drilling.
• Painted finish protects the bracket from chaff corrosion during long idle periods.
• Compact and light, making it practical to keep in stock as part of a feeder service kit.

Fits Massey Ferguson MF 2150, MF 2170, MF 2170XD, MF 2250, MF 2270, MF 2270XD and MF 2290 balers and Challenger LB34BXD, 2270XD, CH LB34B and CH LB44B models. Workshops replace the bracket whenever the dogs are renewed and the pin holes show wear, because a new set of teeth on a loose base will work itself loose again within a few hundred bales.

Brackets are wrapped and boxed with the part number clearly marked, then palletised with matching feeder parts for export. Combined orders of mount, dogs and pivot pins can be packed in one carton so the whole feeder repair arrives together and installation can start without waiting for missing pieces.

Ask us for a feeder kit quotation including the mount, upper and side dogs and pivot hardware. Sending a photo of the existing bracket helps us confirm the variant if your baler has been repaired in the past with non standard parts.